change time BMW 7 SERIES 2001 E65 MOST Bus Diagnosis Workshop Manual

12
MOST Bus Diagnosis
Diagnosis
It is important to remember that on the MOST network, messages can only be transmitted
provided the bus ring is complete and fully functional. If there is a ring fault in the MOST
network, the diagnostic system only communicates with the instrument cluster and the
Control Display because both of these modules are directly connected to the K-CAN
System Bus.
The fiber optic signals on the MOST network always travel in one direction and only in one
direction. Signals always originate at the Control Display and travel to the CD changer, AVT,
Logic 7 (if equipped), SVS, NAV, MultiMediaChanger (if equipped), Telephone, ASK, Kombi
and back to the Control Display.
The MOST bus allows intersystem fault memory entries in the individual control modules.
A feature of the system faults is that faults may be entered in a control module although the
control module is OK. Conclusions may be drawn about the cause of the fault, using the
fault information stored in all the control modules.
The possible system faults are:
 Optical wave guide communication fault (All MOST Control Module) FC 111
 A Control Module does not switch a light off (All MOST Control Modules)
 Network wake-up unsuccessful (Control Display (Gateway), ASK, Telephone Only)
FC E18D
 Ring fault diagnosis run (Control Display (Gateway) and Kombi Only) FC E190
The Control Display functions are split between acting as a Gateway and Displaying infor-
mation. The Gateway function serves as the interface between the MOST and the K-CAN
System buses. Although the Control Display is one control module, two control module
names are displayed in the DIS Plus:
 CD Control Display (Gateway)
 CD Control Display
The faults stored in the Control Display are distributed between the Control Display
Gateway and Control Display according to the function of the fault.

17
MOST Bus Diagnosis
The Control Display will display a relative node number. This number will indicate how many
modules communicated after the module which set the relative node number of 0.
To find the control module with the relative node number of 0, count from the input side of
the Control Display (counting the Control Display as 0) towards the control modules. When
arriving at the control module with the number as displayed as the relative node number in
the DISplus, the last known communicating module has been found.
Example:
While performing the ring break diagnostics the Control Display has set a relative node
number of 2. Count the Control Display a 0, the Kombi will be 1 and the ASK will be 2.
The ring break occurs between the ASK and the module which precedes it, the telephone
module.
Important
When counting control modules, the multimedia changer (if equipped) and the Nav system
must be counted as two control modules.
In order to perform the count correctly the equipment on the vehicle must first be identified.
When using the MOST network diagram in the DISplus, connector number 1 of the optical
waves are inputs and connector number 2 are outputs.
Module input
Terminal 1
Module output
Terminal 2
Module input
Terminal 1
Module output
Terminal 2
12
Workshop Hint
When preparing to initiate a Ring Break Test it is very important that
the removal and reinstallation of the battery cable be quick and with-
out hesitation.
Hesitation removing or replacing the battery cable may cause volt-
age spikes that will render the Ring Break Test void.
Workshop Hint
For repair of MOST optical wave guide use special tools:
61-4-320 Crimping Tool Kit
Refer to
EPC 61_1578 for specific optical wave guide repair parts.